Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to check which 4G band your Huawei B315/B525/B528 router is using
.Before purchasing a band-specific LTE/4G antenna, first check what band you are currently using.  

These steps cover the B315, B525 and B528 and should be the same for most newer Huawei routers such as the B618, etc.  The older Huawei B593 series does not report the band #.

  1. In your web browser, enter the URL:
  2. Click on the Settings tab and log in.
  3. Now go to the following URL:
  4. Right-click the text and click 'View page source'
  5. Look for the band tag as shown in the example below.

These are the common band #s in use in Europe.  Eir, Vodafone and Three in Ireland currently use bands 3 and 20 for 4G
  • Band 1 = 2100MHz
  • Band 3 = 1800MHz
  • Band 7 = 2600MHz
  • Band 8 = 800MHz
  • Band 20 = 800MHz
[quote pid='5' dateline='1579355384']

Should we buy a new antenna then?

Fantastic, useful information as usual, Sean!

So ours is band 20 as expected (three rural antenna on the south coast, screenshots from the mastmap attached)... We have been wondering if we should try getting a better aerial like the one you recently advised as we are in a valley below the mast and speeds have deteriorated a lot in the past year. I think we are getting the signal through a gateway gap in the ditch on the hill above so we might need something more directional!

The speed we get deteriorates in the evening because of contention, we do realise the aerial can't fix that.

This afternoon, the speed we're getting looks good but this is unusual - 16.37 Mb download, 21.4 Mb upload, latency 46 ms, still, perfect weather today too.
The rest of what we see from the B525 is: 

<txpower>PPusch:6dBm PPucch:-15dBm PSrs:0dBm PPrach:-1dBm</txpower>
<dl_mcs>mcsDownCarrier1Code0:0 mcsDownCarrier1Code1:0 </dl_mcs>
<earfcn>DL:6300 UL:24300</earfcn>

What do you reckon? Try another aerial or would it be another €100 down the maw of acceptable broadband speeds?

Thank you. Imogen
I'll be interested in seeing what your figures are in the evening when your speed is at its slowest.  At the moment, those signal readings are actually reasonably good.  I'm surprised the download speed is not much higher, which makes me wonder it's affected by Three's traffic shapping.  Try also refreshing the page a few times to see where the RSRQ and SINR roughly settle around.

Although this may sound ridiculous, when your speed is at its slowest try a download speed test on the "Los Angeles, CA, USA" server on and then repeat with the "London, GB" server.  If the Los Angeles result is much higher, repeat the two tests to rule out a fluke.

Whichever host TestMy is using for its Los Angeles mirror, it happens to be one that gets prioritised in regions affected by Three's traffic shapping.  For example, if you get let's say 4Mbps in your usual speed tests, but get over 10Mbps on the TestMy Los Angeles server, a better antenna upgrade will not improve your regular peak time speed.
Great advice - I'll come back to you when I've figured that out and done more tests.
I am wondering if it would be worthwhile for me to get an external antenna for my router (Huawei B525), currently we are getting around 30-40Mb download speeds and around 1-4 Mb upload speeds. I am on the Three network by the way. The stats from the website are as follows:

<txpower>PPusch:19dBm PPucch:7dBm PSrs:0dBm PPrach:23dBm</txpower>
<dl_mcs>mcsDownCarrier1Code0:2 mcsDownCarrier1Code1:7 </dl_mcs>
<earfcn>DL:1275 UL:19275</earfcn>
Based on the weak RSRP (signal strength), it would be worth getting a directional outdoor antenna to improve this. From what I can tell between the RSRQ and SINR readings, your mast seems to have a low load (unless this was early in the day) and the signal quality is pretty good for such a weak signal.

Your download speed will likely improve depending on the upstream contention to the mast and your upload speed will be much higher, probably 20Mbps or higher. Check this reading again around 9pm to 11pm as this is generally when traffic is at its heaviest.

If you have an Android 9+ phone handy on the 3 network, get the App Network Cell Info and see if 1700 appears on the EARFCN column. You are currently on a former O2 band 3 mast (earfcn is 1275). If your phone shows a 1700 (a native Three band 3 mast) on this column, that means you possibly can get 4G+ between the two band 3 masts. If your masts are connected by fibre, this can potentially deliver over 200Mbps with a good band 3 antenna, such as with two of these:

If you see only 6300 or 1275 or are unable to check with a phone, I suggest getting something like this, which covers all the 4G bands (with less gain). This one would also be easier to align as it's less sensitive to alignment compared to the above narrow band antenna:
Hi, Seán,
Thanks for all the information,
Unfortunately I don't have an android, although when I log into my routers settings it does say that I am connected to 4G+, would you still recommend me to get the antenna off amazon because I wasn't able to check the EARFCN number?
Thanks again for all the information.
In this case I suggest going for that antenna on Amazon as it will cover the 800MHz 4G band that the other one doesn't. Most of Three's 4G+ sites run a combination of 800MHz and 1800MHz for carrier aggregation. Even still, whenever Three runs fibre to the masts (if not already), you can potentially get 100+Mbps when depending on the traffic on the mast.

Three doesn't have that many sites that run 4G+ across two 1800MHz cells, but those that do tend to use a combination of a 4G site using O2's former band 3 spectrum and a native Three 4G site, so when I saw the telltale sign that you're on an O2 mast, I thought it would be worth checking. Most other 4G+ sites use a combination of O2's former band 20 spectrum and Three's own band 3 spectrum. Unfortunately, Huawei's routers only shows technical details for the the main carrier it's connected on, not the second carrier like the newer Android phones can.
Thanks for your help!
Hi Sean

Definitely part of our problem is contention.
At 15.35 in the afternoon before it gets bad, 13.6Mb/s DL from London on v 18.4 Mb/s DL from Los Angeles.

There could be good news on that longer term, as the 4-site National Broadband planning vans are currently around our area. We are 12.5km from Carrigaline which is going to be one of the first towns rolled out... so here's hoping fibre to the local masts might be a priority instead of the current microwave backhaul... and you never know, perhaps we will eventually get fibre that works!

We now have a Wittenberg LAT 22 Duo aerial costing just over €100, which we tested on a lighting tripod to raise it up, but have not permanently installed yet (it's a bit better on speed but not huge). That gives us a rsrq < -9db and a consistent rsrp of -85db. Which is better than our panel antenna. Those figures probably can be improved with a taller mast. Interestingly, we found that mounting one antenna above the other was no different than side by side on a U-bracket?

We wondered what you thought before we do the permanent setup. We do get extreme winds here, so a massively tall mast for our antenna on the gable of the house, although it helps to get over the intervening hill to the three mast, might not be wise...

Thanks as always for your wonderful advice.

That's great news about the National Broadband Plan. Hopefully that'll mean they'll cover your street over the next year or two.

The purpose of the U-bracket is to allow the inclination to be adjusted. With the LAT22 antennas I have, if they are mounted directly on to a vertical pole, there is no way to tilt them up. In my area, the mast is much higher than our house, so tilting them up a few degrees makes a big difference. Even if tiling them up does not improve the signal, tilting them up by roughly 10 degrees will help rain run off. If rains droplets build-up between the two main bars, it will attenuate the signal until the antenna dries off, especially with the horizontal antenna.

While you could re-mount the pole the wall tilted by 10 degrees, a problem here is that the top antenna will be a few cm further back than the other. As 4G transmits with a collinear signal that rotates as it travels, if the signal has to travel a few cm more to reach one antenna than the other, the two antennas will not pick pick up the signals properly cross-polarised, i.e. each would be picking up a partial signal of the other cross-polarised signal as interference.

As you are getting a very good RSRP with a tripod, I wouldn't worry about trying to mount them higher than the house. Basically try to get the SINR figure as positive as possible. You can try mounting them one above the other to start with, however, if rain affects the signal too much (e.g. causes the SINR to fall below 10dB), I suggest mounting them with the U bracket to tilt up by about 10 degrees.

Forum Jump:

Users browsing this thread: 1 Guest(s)