04/07/2023, 11:19 PM
New to the Forum but some great information on setting up Wired backhaul.
Yesterday I setup my MX12 (AX3000) based on the methods outlined on this thread. All looks to be working as expected (Not sure how to tell its all on wired backhaul apart from it doesn't show mesh in the Tenda APP)
Attached image of my setup.
How do you know its on wired backhaul? I see <--> in the app, and I saw a controller and then 2 nodes off the controller. My older MW3's just showed them all connected together without a controller node, where as in the new setup I see controller, then connections from controller to each slave node. And slave nodes have no connection between them.
Anything I could do differently?
Yesterday I setup my MX12 (AX3000) based on the methods outlined on this thread. All looks to be working as expected (Not sure how to tell its all on wired backhaul apart from it doesn't show mesh in the Tenda APP)
Attached image of my setup.
How do you know its on wired backhaul? I see <--> in the app, and I saw a controller and then 2 nodes off the controller. My older MW3's just showed them all connected together without a controller node, where as in the new setup I see controller, then connections from controller to each slave node. And slave nodes have no connection between them.
Anything I could do differently?