16/06/2023, 08:23 PM
I have not encountered this particular issue, a right pain indeed with Tenda not offering any web based or alternative way to configure. I have a few suggestions to try:
Switch off the secondary node and do a factory reset (push pinhole for 20+ seconds) with the primary node, then try the configuration steps with the Tenda App. If it gets stuck connecting, try again with the other node as the primary instead, again with only this node switched on. If it connects, you can switch on the other node and use the "Add nova" to add the one that was switched off to the mesh.
Another suggestion would be to try configuring the connection type as "Bridge" and see if it gets past the connecting stage. If it connects, go into the Wireless Settings and set the desired SSD and Wi-Fi password, Then go into Internet Settings -> Connection type and change this to "DHCP". As the wizard was already complete setting it up as bridge, it should hopefully not go through the wizard again.
Switch off the secondary node and do a factory reset (push pinhole for 20+ seconds) with the primary node, then try the configuration steps with the Tenda App. If it gets stuck connecting, try again with the other node as the primary instead, again with only this node switched on. If it connects, you can switch on the other node and use the "Add nova" to add the one that was switched off to the mesh.
Another suggestion would be to try configuring the connection type as "Bridge" and see if it gets past the connecting stage. If it connects, go into the Wireless Settings and set the desired SSD and Wi-Fi password, Then go into Internet Settings -> Connection type and change this to "DHCP". As the wizard was already complete setting it up as bridge, it should hopefully not go through the wizard again.