Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to set up Tenda Nova mesh for wired backhaul - MW5, MW6, etc.
#67
I have not tried with 3 network switches between both Nova nodes but reckon this configuration should work with the Primary node configured in Bridge mode first. Only use the LAN port on the Primary node. Connect the LAN of the secondary node to the switch. Power on the Primary node first and leave it a minute or two until its LED stops blinking and is lit green, then power on the secondary node.
Reply


Messages In This Thread
RE: How to set up Tenda Nova mesh for wired backhaul - MW5, MW6, etc. - by Seán - 01/02/2023, 08:10 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)