How to set up Tenda Nova mesh for wired backhaul - MW5, MW6, etc.

[Clifford]

Hi All,

I've been reading the threads on setting up the Tenda Nova's.  Like other people in the thread I too have a Virgin Superhub with very bad WIFI signal.  I have just bitten the bullet and purchased the MW12-3 module set.  My plan is to ethernet backhaul 2 of them and WIFI connect the other, is this possible?  Then if I buy additional modules such as MW6 that I can use these just a WIFI modules to connect to the existing mesh where I cannot run an ethernet cable.  Or is it once you ethernet backhaul that you have to do this for every module in the mesh.

I've seen the cable diagram for the MW6 for ethernet backhaul so assume it will be the same for the MW12, I did contact Tenda support but so far they've less than responsive.

Thanks, Clifford