Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to set up Tenda Nova mesh for wired backhaul - MW5, MW6, etc.
#33
(10/12/2020, 12:15 AM)Seán Wrote: After using a Tenda Nova MW6 mesh kit for a few months, it is like a night vs day improvement over using my former ISP router.  Unlike my terrible experience with Wi-Fi repeaters, the Tenda nodes have been very stable using wireless backhaul.  This means if there's a Wi-Fi blackspot without Ethernet connectivity, an extra node will solve that.  

The Tenda Nova nodes support wired Ethernet backhaul, which allows the secondary nodes to extend the Wi-Fi without consuming wireless bandwidth back to the primary mode.  This is particularly useful where the nodes are separated by thick walls or down a long corridor where the Wi-Fi of the primary node does not reach.  [...]

Hello, your thread is very usefull! I have a question I have 3 tenda MW6 can i use baclhaul only beetween 2 nodes? and leave the third connected through wifi?

I also noticed, that sometimes somenode doesn't work properly I have the wifi continuosly disconnect, that is not the primary node because it's always green but alternatively the other 2 nodes included the one connected to the primary...

I hope you can help me, because I think to return them to amazon ... every 1-2 week I have problem

Thank you!
Reply


Messages In This Thread
RE: How to set up Tenda Nova mesh for wired backhaul - MW5, MW6, etc. - by devtechk - 12/01/2022, 02:13 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)